Van fit-out for electricians

Fitting out a van for electricians is done to measure, so the price depends on three factors: the size of your van, your choice of material and the number of modules.

• Size: a compact city van needs fewer modules than a large L3H3.
• Material: steel is the cheapest option, aluminium is up to 30% lighter.
• Configuration: from a basic set with reel holders and a few drawers to a complete workshop on wheels.

That is why we work with a made-to-measure quote: that way you know exactly where you stand, with no obligation and no duty to buy.

The layout follows your work sequence: what you need on every call-out goes at the front, within easy reach. If you mostly do installations, cable reels and cable trunking get more space; if you mostly do repairs and call-outs, sorting drawers with small materials and a fixed compartment for your test equipment case come first. We draw up the layout together with you, based on what has to go in it every day.

In a closed compartment or a holder made to measure, so your multimeter and tester don't slide, get knocked or end up under other materials. The complete fit-out is crash tested and certified (TÜV GS, ECE R17, CE): even in an emergency stop everything stays in place. That way your most expensive tools last years longer.

In drawers with dividers: each type of connector and each fuse gets its own compartment. The drawers pull out fully, even when fully loaded, so you see your whole stock at a glance. You find every part in seconds and see straight away what you need to reorder, before you run out on site.

Yes. The system is modular: you add drawers, cabinets or holders later without replacing the existing fit-out. If a second van joins your fleet, you fit it out identically. That way your employee finds everything straight away and the quality of the work stays the same, whoever is driving.

We fit a standard fit-out smoothly; a complete fit-out is usually ready within two working days. We schedule the fitting shortly after your van is delivered. That way you never miss a call-out. On every fit-out you also get a 5-year full fit-out warranty.

Yes. We have fitting plans for almost every make and model, from a compact city van to a large L3H3. The modules are anchored on the original mounting points of your vehicle, so a leased van is fine too. Together with you, we look at what fits in your model.

In the short term it is, but a wooden DIY build is not anchored and not crash tested. As an electrician you know what mass and speed do: in an emergency stop a loose cabinet with cable reels shoots forward, straight into your bulkhead. Our fit-out is certified (TÜV GS, ECE R17, CE), weighs up to 30% less than steel in aluminium and lasts through several vans. If you take fitting out your van as an electrician seriously, you earn that difference back in time, safety and residual value.

Yes. Fitting out a van for electricians is about lots of small parts, cable reels and sensitive test equipment. The layout therefore focuses on fine sorting by compartment, reel holders and a protected compartment for your test equipment case.

On top of that comes lighting in the load space, so you can work even where there is no power yet. Guntro designs the layout around your work sequence.